This
modification is very confusing and I think is only for
the Japanese version.
I present a
modification here to you has to make on the DR-M50 to
unsling it. This modification makes it possible to open
the bands 130-174+300-340+400-470+800-1000MHz.
On, I guaranteed well nothing, but at me her place goes
very well….
CAUTION: TO BETTER UNSOLDER COMPONENTS CMS IS WORTH
BEING WELL TEAM AND TO BE ACCUSTOMED TO HANDLING
SOLDERING IRON!!!
I deliver the explanation in Japanese to you because I
suppose that the dessinse is enough has him same. BUT,
on my apparatus, version DR-M50H, resistance not here
R420 are R55 and are located in the part not VHF and not
UHF….Moreover I do not see a CPU at all…
Note to finish that the explanation Japanese some
indicates that the point locates under the apparatus has
the place notes “D”, right
A the vertical, end of the turntable must be SODA with the point which is
right with the top of him when one is face has the
apparatus.
Good realization and good courage… REMAIN CAREFUL!!!
|
* The case on the substance is opened
* The below-mentioned cutting
The cutting R420 with respect to the CPU
left
|
After the remodeling frequency
130MHz～174MHz
300MHz～340MHz
400MHz～470MHz
800MHz～1000MHz
|
