KB2LJJ                                                           
 
      Home                               Radio Mods Database and Manuals
 










 

          Modifications for the Alinco DJ-100 / T

                                                                             Expanded RF

 1- Take out battery and antenna.
 2- Remove screws from case and open radio.
 3- Locate $ cut jumpers see drawing.
 4- Clip pin 2 on IC401 (S7116A) and connect it to pin 14 ( for simplex PL tone )
     " clip is located on the TONE SW board ".
 5- Reassemble the radio.
 6- Don't forget to Reset Micro Processor. 

 

    Regards Droswstenvick                        

 
Adjustment points for DJ-100T
 
     

1. Transmitting Unit

 

Item Adjustment Point Adjustment Method Spec
1. Frequency adjustment CV301 (Main PCB) Set the unit in the transmission mode at 144.03 MHz and adjust CV301.
(Transceiver tester, counter)
144.03 MHz
±50 Hz
2. Modulation degree adjustment VR303 (Main PCB) Input a signal of 1 KHz/50mV into the SP/MIC jack and adjust VR303 so that you obtain 4.7 KHz/DEV in the transmission mode. 4.7 KHz
±0.2 KHz
3. Subaudible tone VR401 (RF unit) Set the sub audible tone to 114.8 Hz by DIP Switch and adjust VR401 so that you obtain 800 Hz/Dev. 800 Hz
±50Hz
4. DTMF VR601 (DTMF Unit) Puch [1] in the transmission mode and adjust VR601 so that you obtain 3 KHz/DEV. 3 KHz
±500 Hz

2. Receiving Unit

 

Item Adjustment Point Adjustment Method Spec
1. VCO P/D voltage adjustment L502 (VCO) Adjust L502 so that P/D voltage is 0,5 V at 144.03 MHz. (DC voltmeter) 0.5 V
±0.1 V
2. RF amp L405, 406, 407 & 408
(RF PCB)
1 KHz, 3.5 KHz/Dev. - 6 dBµ (Meter direct reading). 145.03 MHz, audio output 50 mV/8ohm (Transceiver tester)
Adjust L405, 406, 407 & 408 so that SINAD sensitivity becomes maximum.
-2 dBµ Max.
3. Squelch Sensitivity VR301 (Main PCB) 1 KHz, 3.5 KHz/Dev, -8 dBµ (Meter direct reading), 145.02 MHz (Transceiver tester).
Turn VR301 counterclockwise from closed conditions and set to a point where the squelch is open.
-8 dBµ
±1
4. S-meter adjustment VR302 (Main PCB) 1 KHz, 3.5 KHz/Dev, +17 dBµ (Meter direct reading).
Turn VR302 so that [FULL]-bar begins to light.
 

   Have fun Droswstenvick