- Push funk + B at the same time while
you are turning the radio on.
- It will show KL in the display.
- Push # - 2 - 1 - 2, open will kom in
the display.
- To the end, push funk + B and funk + B
again, while you are turning the radio on.
With radio on push funk and scan
together.
- The letters KL will be displayed.
- Push # 2 1 2 the word \"open\" will be
displayed for about 2 sec.
- Push funk and scan togther again
untill KL or FL is no longer displayed.
- Turn off radio and reset pll by
holding funk while turning on radio continue to hold funk for 2
sec after power is on.
Note: All memory will be erased.!
You will see the display fully on
activated. this will give tx and rx from 173.995 to 130.000 mhz.
( pressing funk + B while turning on
power toggles beep mode on and off )
| User comment |
| The
expanded Freq. Mod, has a problem. It works, BUT ONLY AFTER
the jumper above the processor inside the radio is removed.
Remove back cover, locate Processor (aprox 1 inch square) look
just above the processor for a jumper wire soldered to the
board.
REMOVE THAT WIRE JUMPER, then proceed to assemble radio. After
radio is assembled, turn radio on. press and hold (F) and (B)
till KL is displayed. (You will not see what you type) TYPE IN
" #212 ", and you will see the word " open " displayed for a
couple seconds.
Your Radio is open for TX on ALL FREQ's. NOTE: Freq's from 148
to 160 are normally used by LAW ENFORCEMENT COMMUNICATION.
USEING THESE FREQ'S WITHOUT AUTHORIZATION = JAIL TIME. 73'rds |
|
KB2LJJ
