|
Remove the four screws of the
top cover and the cover, in the
rear side of the display board
upper and the left side is
locate one blue jumper, this
select operation and program
mode.
In the left position has set in
operation mode and in the right
is program mode.
-
Change the jumper to program
mode and turn on the power
switch.
-
Whit the button dawn of the
channel knob enter in the Rx
frequency
-
Set whit the knob your Rx
frequency (The button dawn
of the volume change MHz
steep)
-
Push again the button to TX
frequency
-
Set whit the knob your Rx
frequency (The button dawn
of the volume change MHz
steep)
-
Push again the button to Rx
Sub tone set
-
Set whit the knob your Rx
frequency Sub tone frequency
-
Push again the button to TX
Sub tone set
-
Set whit the knob your TX
frequency Sub tone frequency
-
Push again the button to set
the next channel.
If you set all channel turn off
the power and place the blue
jumper in the operation mode.
Turn on the switch and “BINGO”.
Reinstall the top cover and all
screw.
This program mode is similar of
the TK-705/805 from Kenwood |
