Alinco DR-140
                              

Expanded TX mod
  1. Open the top of the case by removing the three screws.
     
  2. Locate the blue loop of wire near the display, facing toward you.
     
  3. Cut the blue loop of wire, and tape up the ends.
     
  4. Replace cover of the radio.
     
  5. Reset the radio by holding the function key down and turning on the power.

          For E-Version (DR-140E) Give RX from 118 - 173 MHz.

  1. Bring the radio into Key-Lock. Press V/M, CALL, SET in this sequence three times. Exit from Key-Lock. If you reset the radio the range will diminish to the original state.

     
  2. Instead of doing the above, you may remove R349 and reset the radio.

 

ATTENTION
The KB2LJJ takes no responsibility for any damage during the modification or for any wrong information made on this modification.