|
While working on 2m band and
high power, when the microphone
is held too close to the
antenna, the PTT 'hangs' in TX
mode when going over to RX
and/or there is sometimes no
modulation during TX.
This is due to RFI on the PTT
line going into the
display/controller unit, and can
be particularly annoying when
working mobile with an antenna
affixed to the front windshield
(like PROCOM 'Glassfix'
dualbander).
Solution :
RFI can be drastically reduced
by inserting a 10 to 22nF
capacitor between PTT line and
ground (scratch a little bit of
the PCB varnish), on the RJ-45
plug in the controller unit. See
picture. If SMD capacitor not
available, then try with a chip
capacitor, solder the 'ground'
side on big solder pad (solder
of the potentiometer casing).

best 73s
Jean-Jacques - ON7EQ
|