ICOM  IC-H16                  
 

1- Remove battery and antenna.                                              
 2- Remove 9 screws and open the case.
 3- Locate and remove JUMPER plug.
 4- Reassemble the radio.

 PROGRAMMING COMMANDS:
~~~~~~~~~~~~~~~~~~~~~
   1- Hold down [FUNCTION] key and press [1] [5] [9] [3] [5] [7].                                            
  
   2- Hold down [FUNCTION] key and press [1] Transmit PL tone. (2 digits)
                                         [2] Receive PL tone. (2 digits)
                                         [4] Offset in MHZ.(ie..+05000=+5 Mhz)
                                         [5] Frequency.
                                         [7] Rename CH#
                                         [8] Time out Timer
                                         [9] TX inhibit
    3- Enter #'s and press [ENTER].
    4- To exit programming mode hold [FUNCTION] and press [CLR].
 

ATTENTION
The KB2LJJ takes no responsibility for any damage during the modification or for any wrong information made on this modification.