ICOM IC-X2A ~~~~~~~~~~~~~~~ EXPANDED RF Modification Instructions for the IC-W2A Handheld Two mods, one for Cross Band Repeat and one for extended TX range 1- Remove battery and antenna. 2- Remove screws from back panel and battery plate and open radio. 3- Remove PLL deck and power plate. 4- Unplug VHF & UHF decks. 5- Remove chip diode D22. 6- ATTACH chip diode to location points A & B. ( diode MA133 - ICOM part # 1790000860 ). 7- Reassemble the radio. 8- RESET the CPU ( Push and hold [ FUNCTION ] & [A] & [CLR] and turn power ON). ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³ R41 IC-X2A ³ ³ ÚÄÄ¿ ÄÄ ÚÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ¿ ³ LOGIC ³ ³ ³ ÜþÜ ´ ÚÄÄÄÄÄÄÄÄ¿ à ³ ³ ÀÙÀÙ / þßþ B ´ ܳÚÄÄ>ÄÄÄß³ DA 133 à ³ UNIT ³ / ÛþD22 Û Û ´ ³ÀÄÄÄ<ÄÄܳ à ³ ³Install\ Ü ´ ÀÄÄÄÄÄÄÄÄÙ Ã ³ ³ þÛ Û þÛ ÀÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÂÙ ³ ³ A Û þÛ ³ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ RX Expansion Push and hold [#] & [B] & [3] and turn power ON. Direct Entry Set VFO PL to 100Hz on VHF and UHF !!! [F] & [SET] to select 1, 10, OR 100 Mhz freq. entry. Xband Repeater ON Hold [FUNCTION] press [2] and them [#] Xband Repeater OFF Push and hold [FUNCTION] & [#] Xband Text Push and hold [#] & [light] & [#] ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º KB2LJJ BBS RADIO MODS BATABASE º All the MODS are captured by packet. ÈÍÍÍÍÍÍÍÍÍÍÍ» ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ This BBS taks no responsability or ÉÍÍÍÍÍÍÍÍÍÍͼ ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» liability for any damege resulting º KB2LJJ @ KB2LJJ.NJ.USA.NA º from this modification. ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ 73s John kb2ljj SySoP