®       Radio Mods Database

        Web Page  http://www.kb2ljj.com                                          Email                   kb2ljj@pacnews.com
                                               KENWOOD TH-26A

 Expanded RF Alignment controls

1 - Disconnect the power and antenna.

2 - Remove 3 screws from the case and 2 from the battery panel.

3 - Open the radio.

4 - REMOVE JUMPER JP1. Use a soldering iron the remove the jumper.
Do not pull the jumper or overheat the board.

5 - Unsolder and remove chip resistor R56.

6 - Reassemble the radio. Carefully re-seat the O-ring on BNC connector.

7 - Reset the microprocessor. ( Press and hold the [ F ] key and turn 
the radio ON ).

NOTE: Automatic offset selection will be disabled when this mod is performed.




                             

All the mods are captured by Packet. 
KB2LJJ    Radio Mods Database 
take now responsibility or liability for any 
damage resulting from this modification.  
                                  
 I have been trying to help our ham radio with the radio modifications and have asked for any type of new radio mods.
 However, I haven't received too many.  If all of you contributed a little more,  I believe I would be able to help 
all the other ham's that are looking for these mods. I know it is possible to get more mods from all the Ham's because of
 the wide range that exist throughout the world.  By doing this we can  flourish and enjoy more of this hobby that 
we've taken part in for so many years. Furthermore, I ask you not to forget to send me any modifications that you might
 have through email.  I would really appreciate it.

      Email                kb2ljj@pacnews.com

 73's
   John Ribeiro
             KB2LJJ