Radio
Mods Database
Web
Page
http://www.hostingme.com/kb2ljj
Web Server http://216.102.57.116
FTTP ftp://216.102.57.116
Email
kb2ljj@pacnews.com
EXPANDED RF
~~~~~~~~~~~~~~~
1 - Disconnect the power and antenna.
2 - Remove 4 screws from the back panel.
3 - Open the bottom of the front panel first and slide the panel downward.
4 - Open the radio being careful not to break the flex cable.
5 - Move the tone board out of the way to expose the green jumper wire
located inside the front panel assembly.
6 - Cut the GREEN jumper wire.
7 - Remove chip resistor R337 ( Disables AM receive & audio offset ).
8 - Reassemble the radio. Carefully re-seat the O-ring on the BNC connector.
9 - Reset the microprocessor. Press and hold [M] key and turn the power on).
All the mods are captured by Packet.
KB2LJJ Radio Mods Database
take now responsibility or liability for any
damage resulting from this modification.
However, I haven't received too many. If all of you contributed a little more, I believe I would be able to help
all the other ham's that are looking for these mods. I know it is possible to get more mods from all the Ham's because of
the wide range that exist throughout the world. By doing this we can flourish and enjoy more of this hobby that
we've taken part in for so many years. Furthermore, I ask you not to forget to send me any modifications that you might
have through email. I would really appreciate it.
Email
kb2ljj@pacnews.com
73's
John Ribeiro
KB2LJJ