Modify FT-270R

  

Remove This Diode To Modify FT270R
           

                      

  • 1- Remove the battery and the caution seal (sometimes a thin black cover) underneath the battery inside the battery compartment. This cover has a small trimmed corner with which to pry it off from, and the cover is adhesive.

  • 2- Find the two surface mount resistors in the midway point between the two white connectors, next to the rectangular opening on the pcb, sometimes the upper resistor will be absent. Be very careful, because these are VERY tiny.

  • 3- Remove/desolder the one or two resistors as applicable, CAREFULLY.

  • 4- Replace the caution/black seal and the battery

To expand the FT270R remove this diode then perform a FULL RESET

 

 

Remember it is Illegal to transmit out of band. This Modification is for Informational purposes ONLY.
Doing such modifications on your radio may void any warranty and damage your equipment.
All mods found on this database are offered to me by other amateur radio hams or captured by Packet system. 
KB2LJJ  take no responsibility or liability for any damage done resulting from any modification.  

ATTENTION
The KB2LJJ takes no responsibility for any damage during the modification or for any wrong information made on this modification.