FT-50R CAP/MARS Expanded Transmit 140-174, 420-470 1 - Remove Battery. (of course) 2 - Remove the Ni-Cd sticker. (use a pair of tweezers or simular to remove without damaging. 3 - Remove the (2) silver screws. 4 - Slowly...Lift off the Keypad and carefully locate the Jumper Pads (the pad does not just pop off! Work with it, may have to use a small screw driver to lift around the edges. 5 - Locate and unsolder jumper #1 (see diagram) 6 - Re-install the Keypad with the (2) screws. (be sure to get the orange seal back in the correct place. 7 - Turn Radio Off 8 - Press down and hold the Top-Notch(tm) and LAMP button while turning on the Radio. Modification Done (now the hard part, REPROGRAMMING THE RADIO!! HI HI.) ** || || || || || || __ ## { } ## __[__]____________ ##_ ( ) | { DISPLAY} | | =========== | | ============= | | ================= | | ============= | | (P) | | | | __________________ | View | ( ) | Looking down without | | 1 2 3 | | Keypad. | | # : : | | (Just touch the iron to | | | | #1 and seperate the jumper, | (__________________) | I'm not sure what happens if (______________________) you jump 2 or 3) 2 & 3 are marked on the board, 1 wasn't. You can't miss it though. Please use common sence when using the mod. It is against the law to use Amateur equipment out of band unless you are a government service that permits this. Or, you are a licensed CAP or MAR person. joao-ribeiro@worldnet.att.net -- USE THE INTERNET TO REACH ME IF YOU HAVE THAT SERVICE OR IF NOT USE THE PACKET ADDRESS. ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º KB2LJJ BBS RADIO MODS BATABASE º All the MODS are captured by packet. ÈÍÍÍÍÍÍÍÍÍÍÍ» ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ This BBS takes no responsability or ÉÍÍÍÍÍÍÍÍÍÍͼ ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» liability for any damege resulting º KB2LJJ @ KB2LJJ.NJ.USA.NA º from any modification. ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ 73s John kb2ljj SySoP