YAESU FT-530 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ EXPD RF New range 110-180 200-500 RX 130-180 400-470 TX 1- Remove battery and antenna. 2- Locate and remove the 4 screws on the bottom battery track. 3- Locate and remove four black screws on the rear case. 4- Carefully open the front cover and open the radio. 5- Note location of white paper insulator and remove it. (Don't throw away). 6- Locate JUMPER location J-13 and remove solder jumper. ATTENTION - Do not both jumper pads 13 and 15. 7- Replace the paper insulator making sure the ground tabs slide through insulator 8- Close the radio being careful not to pinch any wires. 9- Replace all screws. 10- Reassemble the battery and antenna. 11- Reset ( Press and hold [UP] and [DOWN] arrow buttons and turn radio ON. PADS CIRCUIT ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³ ÚÁÁÁÁ¿ FT-530 ³ TONE BURST - Jumper pad # 12 ³ ´ à ³ ³ ßßßß ´ à ³ Stock pads soldered - 1, 3, 6, 8, 11, 13, 15 ³ ÀÂÂÂÂÙ ³ ³ ³ RX above 500 Mhz : Put 300 in lower limit ³ ÚÁÁÁÁ¿ ³ and 950 in upper limit. ³ ÜÜÜÜ ´ à () () ÜÜÜ ³ Press [MR] [MR]. (a line will appear on the ³ ´ à () () ³ display below "L" ³ ÀÂÂÂÂÙ () () ³ ³ () () ³ Enter the desidered frequency. ³ () () Ü ³ ³ () ß ³ ³ ()13 ³ ³ () ()15 ³ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º KB2LJJ BBS RADIO MODS BATABASE º All the MODS are captured by packet. ÈÍÍÍÍÍÍÍÍÍÍÍ» ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ This BBS takes no responsability or ÉÍÍÍÍÍÍÍÍÍÍͼ ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» liability for any damege resulting º KB2LJJ @ KB2LJJ.NJ.USA.NA º from this modification. ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ 73s John kb2ljj SySoP